Bare de precizie din alama, cu sectiune hexagonala WIELAND W5006

Limba: Engleza
2 afisari
Tip documentatie: Fisa tehnica
Salvează pdf
Pagina 1-Bare de precizie din alama, cu sectiune hexagonala WIELAND W5006 Fisa tehnica Engleza Precision...
Pagina 2-Bare de precizie din alama, cu sectiune hexagonala WIELAND W5006 Fisa tehnica Engleza Composition
in...
Pagina 3-Bare de precizie din alama, cu sectiune hexagonala WIELAND W5006 Fisa tehnica Engleza ogeneous lead ...
Pagina 4-Bare de precizie din alama, cu sectiune hexagonala WIELAND W5006 Fisa tehnica Engleza 0

–0.19
...
0 –0.19 Length tolerances For widths across flats of up to 32 mm we supply cut lengths of up to of 3,000 mm ± 30 mm. For larger widths across flats we can also supply cut lengths of up to 3,000 mm ± 100 mm. The definitions of EN 12164 apply to other lengths. (Note: cut lengths are lengths of equal size within a sawn lot.) Edge radii On request sharp-edged or with radii according to EN 12164. Sharp edges are standard for widths across flats of up to 26 mm. Straightness Deviation from straightness (camber) is smaller than 1 mm/m (width across flats 10–30 mm); respectively 1.5 mm/m (width across flats over 30 to 60 mm). Twist For the twist, measured according to EN 12164, we guarantee values smaller than half the limit values defined in EN 12164. End finish Wieland W5006 precision hexagonal rod is supplied with the following standard end finish: Size range (width across flats in mm) End finish 3 to 16 Point and chamfer according to EN 12164 > 16 to 32 One end chamfered acco ... ascunde

Alte documentatii ale aceleasi game
Vezi toate

Bare de precizie rotunde, din alama

Fisa tehnica
4 p | EN
W5000
Profile WIELAND de cupru

Fisa tehnica
8 p | EN
Lucru în România